Clamp Earth Resistance Tester .
Ground resistance measurement.
Power Supply : 6VDC,4 PCS of AA Alkaline batteries.
Port: Shenzhen
Minimum Order Quantity: 100 Piece/Pieces
Contact Supplier
Clamp Earth Resistance Tester ETCR2000+
1. Introduction
ETCR Clamp Earth Resistance Tester is widely applied in ground resistance measurement, loop resistance measurement in fields such as electric power, telecommunications, meteorology, oil field, architecture and industrial electrical equipment, etc. When measuring ground system with loop, there is no need to disconnect the ground wire without auxiliary electrode, which means safer and faster. ETCR Clamp Earth Resistance Tester can measure the ground fault which can not be measured by traditional method, can apply in the occasion where traditional methods are unworkable; ETCR Clamp Earth Resistance Tester measures the integrated value of ground resistance and resistance lead.
2. Technical Specifications
Function Ground resistance test, Loop resistance test
Power Supply 6VDC , 4 PCS of AA Alkaline batteries
Resistance Range 0.01-1200Ω
Resistance Resolution 0.001Ω
Highest Resistance Accuracy ±1%±0.01Ω
Data memory 99 Sets
Alarm Threshold Setting Range Resistance: 1-199Ω
Alarm Sound and Light “Beep-beep-beep” alarm tone, Alarm Symbol Flashing, Press AL key to turn on, turn off Alarm or set Alarm Threshold.
Interference Signal Recognition
"Beep-beep-beep" tone, NOISE symbol blinking
Working Temperature and Humidity -20°C-55°C. 20%RH-90%RH
LCD Screen 4 Digits LCD display, Screen L×W: 47mm×28.5mm
Clamp Size 65mm×32mm
Clamp Opening Extent 32mm
Tester Weight 1160g (With batteries)
Clamp Dimension L×W×T: 285mm×85mm×56mm
Protection Level Dual Insulation
Structural Feature Clamp CT
Shifting Automatic shifting
External magnetic field <40A/m
External electrical field <1V/m
Single measurement time 0.5 second
Resistance measurement frequency >1KHz
Measured current frequency 50/60Hz Automatic measurement
Low Battery Indication Low battery symbol displays when battery is lower then 5.3V
Memory Full Indication MEM symbol blinks when all 99 sets memory is full
Over Range Indication Out of range indication “OLΩ”, “L0.01” or “OL A”
Auto Power-off 5 minutes after Boot up
Power Consumption Max 50mA either in booting up or normally working, Continuously working for 30 hours
RS232 Interface (Optional) The data stored in the meter are uploaded to the computer through RS232 interface and data wire, Then generate report files
Safety Provisions IEC1010-1, IEC1010-2-032, Pollution level 2, CATIII (600V)
Accessories Meter: 1 piece, Test ring: 1 Piece, Meter Suitcase: 1 Piece