1. new generation product
2.pass ISO and MC certification
compliance with: EN196/1, EN 196/3 and EN 480/1.
Port: qingdao
Minimum Order Quantity: 1 Set/Sets 1
Supply Ability: 100 Set/Sets per Month 2
Payment Terms: L/C,T/T
Contact SupplierPackaging Detail: compression plate
Delivery Detail: 10day
horizontal shaft concrete mixer
This mixer Division mixing of ordinary concrete, lightweight concrete, dry concrete, can also be applied to other industry laboratories for mixing of different materials.
compliance with: EN196/1, EN 196/3 and EN 480/1.
horizontal shaft concrete mixer
Technical parameters:
1, the feed capacity: 48 liters, the discharge capacity: 30 liters to 96 liters (30 type), the discharge capacity: 60 liters (60 type)
2, the maximum discharge capacity: 33 liters (30 type) 66 liters (60 -)
3, the mixer speed: 48 turn / min.
Stir time: ≤ 45 seconds
Compulsory single horizontal shaft concrete mixer operating procedures
1, before the start of compulsory uniaxial concrete mixer, first check the rotating part of the barrel scratching if collide phenomenon, should be timely adjusted.
2, the gear box should be injected into oil in order to use the discharge the Worm pay and sliding bearings at the injection oil.
3, cleaning the barrel, miscellaneous material.
4, start the mixer cylinder limit device locking, and then start.
Kai opened, blenders, the direction of rotation does not meet the requirements, they should cut off the power conductor of any two lines are reversed and then restart.
6, concrete mixing materials into the barrel, close the cylinder cap.
7, according to the timing of the mixing time to adjust the time relay, pay attention to adjustment in case of power outages.
8, pressing the start button, spindle driven mixing shovel operation.
Reach adjust timing ask automatically.
10, the discharge concrete mixer first stop, then release the cylinder-bit limit set handle, and then rotating the handwheel worm gear to pay to drive the barrel rotation to facilitate the location of the discharge, stop turning, and then start the machine spindle running of discharge of materials, until materials row net stop spindle operation of rotating the hand wheel so that the barrel reset.
11, cleaning the barrel, the water poured into the barrel so that the spindle running the barrel and shovel piece rinse or sand cleaning can also be
Compulsory single horizontal shaft concrete mixer, maintenance and repair
bearing components l, according to the use of regular lubrication, gear box lubrication reference manual.
Regular inspection of the machine sealed case, leakage the pulp Department shall promptly check the quality of the seal.
3, regular checks of the piece of sturdy shovel, if loose should be promptly tighten.
4, regular checks of the electrical control system is a good contact and dry.
5, the mixer by long-term use, shovel plate and mixing tube wear, adjust or replace the wear and tear.
6, in the mixing process, not to the hand and rod-like object into the barrel so as to avoid danger.
horizontal shaft concrete mixer
Friendly Tips:
We garantee the product description is true and effective. After installation, for your safety, please use the instruments grounding.In the first year of your using the product, we replace the damaged parts.(Except consumables )
With decades of experience, we can provide a wide range of professional laboratory solutions. Please contact us if you can not find your desired lab equipment on our website. We will help you to find manufactures who can guarantee the quality.