UHZ magnetic flapper (level gauge) - UHZ

UHZ magnetic flapper level indicator

Used in liquid level measurement in petroleum and

chemical industry and etc. It can be used for long distance alarming

and level control if add upper and lower limit switch output.

Configure the transmitter, change to 4~20mA or 0~10mA

standard current output. Connecting to display meter or computer,

remote liquid level display measure and control can be implemented.

Providing 2 kinds of installation: side install and roof install.

Providing 4 kinds of material: stainless steel, stainless steel lined

with PTFE and ABS, PP-R and ABS.

Overview

UHZ series magnetic float liquid level gauge can be high sealed, anti-leakage.

It's suitable for low or high temperature, vacuum, high pressure, high viscosity, high corrosion and so on.

It's ideal liquid level measurement products for petroleum, chemical and other industrial sectors.

According to different media, we provide five basic model which are stainless steel,ABS, PPR,

PTFE lined stainless steel, PVC . ABS,

PPR, PVC, UPVC, PTFE lined stainless steel can be applied to corrosive media such as acid and alkali.

Features

1, Utilize float as the measuring element, the magnet steel drive the column to turnover, external energy is not needed.

2, Coupled with lower limit switch output, long distance alarming and liquid level control is available.

3,Coupled with transmitter, long distance liquid level indication, detection and control is available.

4, No dead zone in the whole measurement range, eye-catching display, intuitive readings, wide measurement range.

Structure principle

Liquid level gauge works according to the buoyancy principle and the magnetic coupling principle.

When measuring liquid level go up or down in the container, the float of the gauge also goes up or down in the tube.

The permanent magnet inside the float couples the magnetic to

the indicator, drive red and white columns turn 180 °. When liquid level

rise, the column or flap turn from white to red. When the liquid level fall,

the column or flap turn from red to white. The red and white edge in the indicator indicate the actual liquid height.

Installation and operation

1.Firstly, check the technical data in the label plate whether consistent with the requirements of the order.

2.There should be no magnet material around 200mm of the level gauge, otherwise the level gquge may work abnormally.

3.After long distance transportation, the red and whithe magnetic columns may be intermingled before installation. In this case, move the appendant calibration magnetic steel from top to bottom on the surface of the indicator, it will make the indicator display all white.