Portable TGas-1022 Gas Leak Detector:
1.gas sensor using high-quality
2. high stability,long life
3.anti-poisoning ability
Port: Zhengzhou
Minimum Order Quantity: 1 Piece/Pieces
Supply Ability: 50 Piece/Pieces per Week
Payment Terms: T/T
Contact Supplier
TGas-1022 Portable Gas Leak Detector
Product Description:
TGas-1022 series of gas leak alarm, gas sensor using high-quality, high
stability, long life, anti-poisoning ability, and wide input voltage characteristics,
is suitable for the safe use of household gas, high-quality products.
Basic parameters:
For gas: natural gas liquefied petroleum gas artificial gas liquefied
petroleum gas (hydrogen)
Alarm settings: <25% LEL (natural gas, liquefied petroleum gas)
2560-750 * 10-6 (artificial gas)
Ambient temperature range: -10 °C --- 55 °C (indoor use type)
Temperature range: <95%
Input voltage range: AC180-270V/50HZ DC12V
Storage temperature range: -25 °C -55 °C
Pressure limit : 86-106KPa
Power: the static power consumption <2W, the dynamic power consumption
<3W
Life: 3 years
Use: Indoor
Installation instructions:
For liquefied petroleum gas alarm should be installed from the ground in less
than 30cm, more than 2cm from the floor and walls at the location, the location
away from the kitchen is less than 4M; for natural gas and artificial gas alarm
should be installedin the heart from the ceiling is less than 30cm, the ceiling
and walls, the position is greater than 2cm away from the location of kitchen is
less than 8m.As shown in Figure -2.
Marked in Figure 1, signal line connected to the valve, then the red positive,
black then negative.
Installation
First alarm panel installed in the hanging wall, then hanging in the hanging
alarm panel.
Instructions for use:
1, in accordance with "installation instructions" in the alarm installation
requirements will be fixed.
2, connected to power, when the green light, the alarm in the warm state, can
not carry out normal testing.
3, 3-4 minutes after the alarm into the normal working condition.
4 If the alarm sounding, and long bright yellow light does not put out, that this
time the sensor is not working properly.
5, alarm: When reaching a dangerous concentration of gas leakage, the red
lights flashing, the alarm was given a "tick - tick - tick" sound the alarm.
For control function alarm, the alarm will be the output voltage after 10
seconds or off signals to control the device.
Key features
"Self test" button This button is used to detect sound and light alarm devices
are working properly, press this button, the red alarm indicator light, while the
alarm should sound.Press and hold this button for 3 seconds, the alarm will
have the alarm control signal output.