FLOW ORIFICE PLATES
&
FLOW NOZZELS
Payment Terms: L/C,T/T
Contact Supplier
Definite advantages result from the use of flow nozzles. For a given ratio of throat pipe to diameter, flow nozzles permits
approximately 60% greater capacity than an orifice plate. Flow nozzles can be inserted in pipe-line, where fluid operating
condition do not permits use of orifice plates. (Erosion, etc.) Flow nozzles manufactured accordino to:
ASME, ISA, UNI, DIN, B.S., etc. standards.
Flow nozzle LONG RADIUS type
- From forged piece.
- Entry with elliptical curve convergent to a cylindrical throat
- Profile of elliptical curve checked with special instruments
1 - High “beta” type - b from 0,25 to 0,80.
- Inlet pressure taps located on pipe wall at “D” upstream of nozzle
elliptical inlet section.
- Outlet pressure taps located on pipe wall at “1/2 D” downstream
of the beginning of the elliptical inlet section of the nozzle.
- Two couples of pressure taps with 1 8O0orientation supplied as
std Other type of pressure taps on request
2 - Low “beta” type - b from 0,20 to 0,50.
- Inlet pressure taps located on pipe wall at “D” upstream of nozzle
elliptical inlet section.
- Outlet pressure taps located on pipe wall at “1,5 D” downstream
of the beginning of the elliptical inlet section of the nozzle.
- Two couples of pressure taps with 180° orientation supplied as
std Other type of pressure taps on request