Innovative incircuit, functional,mechanical and bare board test fixtures - 75mil

About The Production

1.With the contacting zone is availqable in a large choice of Tips-styles.It must provide the smallest possible contact resistance between the Test probe and test point, to ensure that measurement results are not distorted,most of plungers will be made of BeCu,and as the resistance,B.T.TECH change the way,test probe plunger will be gold plated!!

2.Every kind of Plunger will be used in different situation.

About Platings

The several components of probes(plungers,barrels and springs) are subjected before assembling to particular galvanic treatments that determine their conductivity,durability,hardness and abrasion resistance features.Herewith we list the main treatments requested and used in our internal galvanic plant:

·HARDGOLD: It has a hardness,depending on its nickel percentage,from 200 to 350 HV.It has excellent chemical properties becoming the suitable treatment to have the best electrical contact.For a better aesthetic aspect(hardgold treatment has a dull colour) it is usually covered by a little layer of pure gold.

·ELECTROPLATED NICKEL:Its hardness is 200-220HV.This treatment treated.

·CHEMICAL NICKEL:It's much harder than electroplated nickel,reaching 600-700HV with peaks of 850-900HV when then heat treated.Electrical resistance goes from 70 to 100 micon-omega/cm.Usually it is used as first layer for the treatment hardgold+flash gold of plungers.

·RHODIUM:This is a very hard metal(up to more than 1000HV)but its deposit is not always uniform and constant.This negatively influence the electrical conductivity in comparison to the better hardgold+flash.

About Test Conditions

Ambient Temperature:23°

Relative Humidity:40%

Continues current flow for 3minutes to reach the current rating,then current at 120% of the current rating for 90 seconds and finally of 150% of the current rating for 60 seconds

About Purchase

HOW TO ORDER:

NOTES:

1.MODEL: you would choose which Minimum Centers probe needs(TOP075 means 75mil)

2.HEAD: it means you choose which plunger (C means RADIUS PROBE HEAD)

3.HEAD DIA:it means you choose the diameter of Plunger(064 means 0.64mm)

4.SPRING FORCE(2/3 TRAVEL):it means the force of spring when it is tested within 2/3 travel(100 means 100g)

5.PLUNGER PLATING:it means Platings material(G means gold)

6.LONG/SHORT:it means long probe or short probe

IF you have any problem,Please contact us directly!!! We will try our best to support service for you!