Datcon 103191 Smart 2000 Oil Temperature Gauge Model 828

Datcon 103191 Smart 2000™ Oil Temperature Gauge Model 828

Manufacturer's Link: http://www.datcon.com/Tables/smt-T1.htm#op0

Smart Instruments®

Smart Instruments® provide a variety of ways to monitor critical parameters such as fuel, temperature, pressure and battery levels. Depending on which Smart Instrument® is selected, the system will display a visual alert, trigger an audible warning, or trigger a switch which will initiate a rapid engine shutdown.

GENERAL DESCRIPTION:

Integrated warning lights, switch outputs & engine shut-down features for Datcon brand Automotive, Heavy Duty Industrial & IllumaSeal® instruments · Ideal for protecting valuable O.E.M. equipment especially in cases where operators might not otherwise be aware of potential problems · Functions monitored include oil pressure, water temperature, volts & fuel level · Systems allow customers to eliminate costly sender/switch combinations, detection modules, extra wiring & connectors for an "all-in-one" solution · Sensing electronics - sender, switches and LED warning lights - are incorporated inside gauge · Detection circuitry is matched to the instrument for improved accuracy, thus eliminating the gauge as a potential source of system variation (as caused by so-called tolerance "stack-ups") · Three versions allow for natural "option-up" strategy depending on function required and budget considerations

SERIES 2000™

Smart Instrument® ; system that monitors engine oil pressure and temperature, battery voltage & fuel levels · Integral ultra-bright red or amber LED located in center of gauge activated by the following conditions: high temperature, low or high battery voltage or fuel level · Wide range of set points, factory calibrated

SERIES 2001™

Same as Series 2000™ except that system includes a 2-amp switch output configured as normally open in a switch-to-ground configuration · Rugged MOSFET transistor powers switching over an operating temperature range of -40°C to +85°C · Monitor oil pressure and water temperature functions only · LEDs are located either left or right of center on the gauge dial. Factory-calibrated

SERIES 2002™

Integrated LED warning lights - pre-alarm for low oil pressure or high water temperature (located left of center on the dial) and shut-down warning mode (located right of center) · Integral engine shut-down function with optional delay/timer (if customer's engine does not include a built-in delay feature to compensate for low pressure on start-up) · 2-amp switch, MOSFET type transistor · Factory-calibrated with added feature of allowing for field calibration which in turn allows customer to use single part number for multiple configurations

APPLICATIONS:

Consult with factory representatives or your distributor to verify applications. Correct installation is critical to ensuring desired performance.