DMDF-OP-A Partially Filled Pipe and Open Channel Flow meters - DMDF-OP-A

Applications:

1. Open Channel Flow

2. Partially pipes

3. Water treatment

4. Sewage treatment

5. Irrigation

6.Industrial waste

7. Environmental monitoring

DMDF-OP-A Fixed Partially Filled Pipe Flow meters

(If installation environment requires explosion-proof, please contact manufacturer to order DMDF-OP-A Explosion-proof partially Filled Pipe Flow meters.)

DMDF-OP-A flow meter includes flow calculator, transmitter, velocity transducer and level transducer.

Flow Calculator of the flowmeters:

The flow calculator can set the cross-sectional area calculation of partially filled pipe or open channel, for circular pipe, it only need to input the inner diameter; for open channel, it only need to input the width; users also can input up to 20 point coordinates of channel to calculate the cross-sectional area. The flow calculator can display the velocity, level, flow rate and flow totalizer, and is configured with 4-20mA and, RS485/MODBUS output, GPRS is optional.

Flow Calculator

The flow calculator can set the cross-sectional area calculation of partially filled pipe or open channel, for circular pipe, it only need to input the inner diameter; for open channel, it only need to input the width; users also can input up to 20 point coordinates of channel to calculate the cross-sectional area. The flow calculator can display the velocity, level, flow rate and flow totalizer, and is configured with 4-20mA and, RS485/MODBUS output, GPRS is optional.

Transmitter of the flow meters:

The transmitter and level transducer output 4-20mA analog signal of the velocity and level, which are connected to the two external 4-20mA input of flow calculator.

Velocity Transducer

The velocity transducer includes two types: Clamp-on and Insertion, both of them are hot-tapped installation and demounted online.

When installing the insertion velocity transducer, the pipe can’t be welded directly, such as cement pipe, ductile iron or other unweldable material, please notify manufacturer for extended velocity transducers (wall thickness of pipe can be up to 110mm) shown as below. In this case, it also need to install a weldable (usually carbon steel) hoop

Level Transducer of the open channel flow meters

The measurement principle of level transducer: the level transducer uses ultrasonic level meter of special small-scale and low dead zone to measure the level. When installing the level meter, user needs to fix a welding base, the height welding base is usually 80~100mm, so it can ensure a high measurement accuracy.