Compact size, light weight, low power consumption of less than 15 W, and with the capacity to drive up to eight units in parallel.
The R3755A network analyzer evaluates the frequency characteristics of electronic components, such as the crystal resonatorand ceramic resonator used in a broad range of electronic equipment, as well as antennas for receiving/transmitting wireless signals.
R3755A Key Specifications
Measurement functions
Measurement channels: 4
Measurement parameters: A/R (R channel is connected internally)
Signal source characteristics (25C° ± 5C°, calibration cycle one year)
Frequency characteristics
Range: 10 kHz to 300 MHz
Resolution; 1 mHz
Accuracy: ±20 ppm (OPT.20: ±1 ppm)
Output characteristics
Range: 10 kHz to 1 MHz: 0 to -30 dBm
1 to 300 MHz: +18 to -43 dBm 0.1 dB resolution
Range set-up: Start/Stop, or Center/Span
Sweep type: Arbitrary sweep of specified segment
(Frequency, Output level, RBW, Point,
Settling time)
Sweep speed: Maximum 50 μsec/point (RBW 15 kHz)
Measurement point: Maximum 1601 points (segment)
Output port: SMA (female) 50Ω connector
Receiving section characteristics (25C° ± 5C°, calibration cycle one year)
Input characteristics
Input: SMA (female) 50Ω connector
Frequency range: Same as the signal source characteristics
Average noise level: -70 dBm (RBW: 1 kHz)
Resolution bandwidth: 10 Hz to 15 kHz (1, 1.5, 2, 3, 4, 5, or 7 steps)
Error correction functions: Normalize, Trans Full Call
(Full Call: Open, Short, Load)
Connections to external devices
Parallel I/O: 8-bit output (C-MOS), 4-bit input (C-MOS)
General specifications
Loadable PC 1)
Expansion-slot 2): PC which carries 1 PCI slot
(32 Bit, 5 V, half-size)
OS: Windows XP
Development environment
of application: Microsoft Visual Basic 2008 or Visual C++2008
Microsoft Visual Basic 6.0 or Visual C++6.0
Power supply: +5 VDC (5W), +3.3 VDC (5W), +12 VDC (1W),
-12 VDC (1W) (typical)
Power consumption: 15 W or less
External dimensions: Approx. 190 (W) x 126 (H) x 20 (D) mm
Mass: 1 kg or less